Setting up your sprayer


1. Remove the nuts and bolts, holsters, and nozzles from the tank strainer. Set aside. Bring the ComfortStraps™ to the bottom of the tank. Secure the lower strap clips to the loops at the bottom of the tank. Next, slide the adjustable strap through the top tank loop. Continue by sliding the strap over and under the buckle fitting. Lightly tug to make sure the strap is secure. Repeat on other side.


2. Place the top wand holster at the protruding holster mount on the tank. While holding the top holster, place a nut on one side of the hexagonal slots and screw the bolt through the other side until it fastens into the nut. Repeat for the other slot and the bottom holster.


3. Take the spray gun and attach it to the threaded fitting on the end of the hose. Tighten the fitting to ensure the gasket properly seals the connection.


4. If spraying with the stainless-steel spray wand, pull back on the collar of the quick-connect fitting on the spray gun. Insert the male wand quick-connect into the female spray gun fitting and push the collar back into its original position. Nozzles can be attached with the same process.


5. Snap the spray wand into the wand holster and place any unused nozzles into storage slots until ready to spray.



Preparing to spray

1. Fully charge the battery prior to the first operation. Note: the indicator lights will flash green while charging. Solid green lights mean the battery is fully charged.

2. In a separate container, prepare the solution you wish to spray according to the manufacturer’s instructions. Open the tank lid and carefully pour the solution through the tank strainer. Securely tighten the tank lid.


3. Determine the nozzle you want to use and insert it into the spray wand or spray gun by pulling back on the collar of the quick-connect fitting. Remember to push the collar back into position.

    

    a) Adjustable cone nozzle: ranges from jet stream to conical mist. 

    b) Green fan nozzle: flat 25˚ fan 

    c) Red jet nozzle: 0˚ narrow stream


4. Begin spraying by squeezing the spray trigger.


You can also watch this video https://youtu.be/ZxpN85N-bDA